Page 9 - TBIS_15194-2019_(EN)_3nd

TBIS 15194:2019
Taiwan electrically power assisted cycle industry standard

1. Scope

This industry standard applies to EPAC bicycles for private and commercial use with

exception of EPAC intended for hire from unattended station.
This industry standard is intended to cover all common significant hazards, hazardous
situations and events (see Clause 4) of electrically power assisted bicycles, when used as
intended and under condition of misuse that are reasonably foreseeable by the
manufacturer.

This industry standard is intended to cover electrically power assisted bicycles of a type
which have a maximum continuous rated power of 0,25 kW, of which the output is
progressively reduced and finally cut off as the EPAC reaches a speed of 25 km/h, or

sooner, if the cyclist stops pedalling.
This industry standard specifies requirements and test methods for engine power
management systems, electrical circuits including the charging system for the design
and assembly of electrically power assisted bicycles and sub-assemblies for systems
having a rated voltage up to and including 48 V d.c. or integrated battery charger with a

nominal 230 V a.c. input.
This industry standard specifies safety and safety related performance requirements for
the design, assembly, and testing of EPAC bicycles and subassemblies intended for use

on public roads, and lays down guidelines for instructions on the use and care of such
bicycles.
This industry standard applies to EPAC bicycles that have a maximum saddle height of
635 mm or more and that are intended for use on public roads.

Maximum saddle height
Bicycle type City and trekking Young adult Mountain bicycles Racing
bicycles bicycles bicycles
maximum 635 mm or more 635 or more and 635 mm or more 635 mm or
saddle height less than 750 more

第 1 頁共 162 頁